Chapter 9: Global Settings, Syslog, Event Notification and Firewall 69
Event Notifications - Events
The Events screen lists 55 preconfigured ACS 6000 console server events, each of which can be configured for
SNMP Traps, Syslog, DSView, Email and SMS.
To configure Events:
1. Click on Appliance Settings - Event Notifications - Events. The Events screen is displayed.
2. Locate the events for which you want notification sent and select the checkbox or checkboxes
next to the event number(s).
3. Click Edit. The Events Settings screen is displayed. The selected event numbers are shown at
the top.
NOTE: When selecting more than one event number to edit, changes made on this screen will be applied to all of
the selected event types when they are saved.
Email: Server Enter the IP address of the email server where event notifications will be sent.
Email: Port Enter the port number of the email server to be used for event notifications.
Email: Destination Email Enter the email address of the event notifications recipient.
DSView: DSView 3 Server Enter the IP address of the DSView 3 server where event notifications will be
sent.
DSView: Syslog Server
Port
Enter the syslog server port number for the DSView 3 server.
DSView: SSH Server Port Enter the SSH server port number for the DSView 3 server.
DSView: SSH User Name Enter the SSH username for the DSView 3 server.
DSView: SSH Idle Timeout
(sec)
Enter the SSH idle timeout (in seconds) for the DSView 3 server, used to close
the SSH tunnel if it is idle.
DSView: SSH Start
Threshold (bytes)
Enter the SSH start threshold in bytes for the DSView 3 server, used to set up
the parameters if the DSView 3 server does not respond.
DSView: SSH Tunnel
Buffer Size (bytes)
Enter the SSH tunnel buffer size in bytes for the DSView 3 server, used to set up
the parameters if the DSView 3 server does not respond.
DSView: Buffer Full First
Warning (bytes)
Enter the number of bytes allowed by the DSView 3 buffer before the first buffer
full event notification is sent (when DSView 3 server does not respond).
DSView: Buffer Full Second
Warning (bytes)
Enter the number of bytes allowed by the DSView 3 buffer before the second
buffer full event notification is sent (when DSView 3 server does not respond).
DSView: Buffer Full Third
Warning (bytes)
Enter the number of bytes allowed by the DSView 3 buffer before the third buffer
full event notification is sent (when DSView 3 server does not respond).
Table 9.1: Event Notifications - Settings Screen Description (Continued)
Name Description
To Next Page
Loading...
