finished entering the keystroke sequence that will activate the new macro, press the Down
Arrow key.
4. On the line below the macro keystroke sequence you just entered, type the keystroke
sequence that you wish the macro to perform.
5. Repeat steps 3 and 4 to configure additional macros.
6. When finished, press Enter to return to the previous screen.
Using History mode
History mode allows you to examine the contents of the history buffer, which contains the
events that have occurred.
The serial IQ module maintains a buffer containing 240 lines minimum, or 10 screens, of
output. When the history buffer is full, it will add new lines at the bottom of the buffer and
delete the oldest lines at the top of the buffer.
NOTE: The Config Key Sequence, On-Line Key Sequence and Clear History Key Sequence used in the following
procedure are the default values. These key combinations can be changed using the Terminal Applications menu.
To use History mode:
1. Press Ctrl-F9. The mode will display as History.
2. Press one of the following key combinations to perform the indicated action:
• Home: Move to the top of the buffer.
• End: Move to the bottom of the buffer.
• Page Up: Move up one buffer page.
• Page Down: Move down one buffer page.
• Up Arrow: Move up one buffer line.
• Down Arrow: Move down one buffer line.
• Ctrl-F8: Enters Configuration mode. The Configuration screen will appear.
• Ctrl-F9: While in Configuration mode, returns to the previous screen with History
mode enabled.
• Ctrl-F10: While in Configuration mode, returns to the previous screen with On-Line
mode enabled.
112 DSR® Switch Installer/User Guide
To Next Page
Loading...
