Avocent DSR - Managing Device Properties; Viewing and Changing Appliance Configuration Information

Managing Device Properties
Viewing and changing appliance configuration information
The DSR switch can report most device properties directly through the DSR switch web
browser.
NOTE: Users can view all appliance information, but only administrators can change settings.
Table 4.5: Viewing Appliance Information
To do this: Select this:
Display the unit’s name or type Appliance - Overview
Display a list of available target devices, their type
and status
Target Devices
Enter, change or display the unit’s IP version,
network address, gateway address, subnet mask,
prefix length (if IPv6 mode), MAC address, LAN
speed, DHCP enable status, ICMP ping reply
status, SNMP enable status or primary, secondary
or tertiary DNS servers
Appliance - Appliance Settings - Network
Display the unit’s current firmware revision for
application, boot and Video FPGA
Appliance- Appliance Settings - Versions
Display a list of the attached IQ module and its
status
Appliance - Appliance Settings - Ports - IQ modules
Display a list of active KVM sessions and their
duration
Appliance - Appliance Settings - Sessions - Active
Display a list of active sessions Appliance - Appliance Settings - Sessions - Active
Display a list of devices attached to the DSR switch Appliance - Connections
View the unit’s part number, serial number and EID
number
Appliance - Properties - Identity
Enter or display the unit’s Site, Department and
Location
Appliance - Properties - Location
Enable the Inactivity Timeout
Appliance - Appliance Settings - Sessions - KVM settings
Then click the Enable Inactivity Timeout box
Chapter 4: Web Interface Operations 57