NOTE: If the Clear, Setup and Commands buttons do not appear on the OSCAR Main dialog box, OSCAR
interface configuration may have been disabled via the DSView 3 software. For more information, please see the
DSView 3 Installer/User Guide.
NOTE: If you are using a DSR switch equipped with dual power supplies, you will be alerted if either of the power
supplies fails by a yellow triangle with an exclamation point that will appear below the target device status symbols on
the Main dialog box only. Click on the symbol for information on which power supply failed.
Figure 3.1: OSCAR Interface Main Dialog Box
Table 3.3: Main Dialog Box Functions
Button Function
VMedia
Set virtual media options and make virtual media connections. This option is only available
when a KVM session is in progress on a virtual media enabled DSR switch.
Log Out Disconnect the KVM and user sessions.
Clear Clear all offline IQ modules.
Disconnect Disconnect the KVM session.
Setup Access the Setup dialog box and configure the OSCAR interface.
Commands Access the Commands dialog box.
Setting virtual media options
If your DSR switch has the virtual media option, you can determine the behavior of the switch
during a virtual media session using the options provided in the Virtual Media dialog box.
Table 3.4 outlines the options that can be set for virtual media sessions.
Table 3.4: Virtual Media Options
Chapter 3: Local Port Operation 21
To Next Page
Loading...
