To do this: Select this:
Change the unit encryption level
Appliance - Appliance Settings - Sessions - KVM settings
Then select the level of encryption desired for
keyboard/mouse signals and then video signals
Change the modem time-out settings Appliance - Appliance Settings - Ports - Modern
Power Controlling Target Devices
NOTE: You must have administrator privileges to change power control device settings.
If a target device is connected to a power control device outlet, you may power up, power
down or cycle (power target device down and then up) the target device using the DSR switch
on-board web interface.
To power up a target device:
1. Select Appliance - Appliance Settings - Ports - Power Units from the DSR Explorer
window.
2. Click the name of the unit you wish to power up, and select Sockets.
3. Select the checkbox to the left of the device that you wish to power.
4. Click the On button.
To power down a target device:
1. Select Appliance - Appliance Settings - Ports - Power Units - Sockets from the DSR
Explorer window. The sockets window will appear.
2. Select the checkbox to the left of the device that you wish to power down.
3. Click the Off button.
To power cycle a target device:
1. Select Appliance - Appliance Settings - Ports - Power Units - Sockets from the DSR
Explorer window. The sockets window will appear.
2. Select the checkbox to the left of the device that you wish to cycle.
3. Click the Cycle button.
To change the minimum on time, off time or wake up state:
1. Select Appliance - Appliance Settings - Ports - Power Units - Sockets from the DSR
Explorer window. The sockets window will appear.
2. Click the socket name that you wish to modify.
58 DSR® Switch Installer/User Guide
To Next Page
Loading...
