Figure 4.5: LDAP Query Page in the On-board Web Interface
To configure LDAP query parameters:
1. Select Appliance - Appliance Settings - User Accounts - LDAP Accounts - Query.
2. Select either Basic, User Attribute or Group Attribute for the Appliance Query Mode and
the Target Device Query Mode.
3. Enter the appropriate information in the Group Container, Group Container Mask, Target
Mask and Access Control Attribute fields.
4. Click Save.
NOTE: These options cannot be changed if the LDAP Priority is set to LDAP Disabled on the Overview screen.
Appliance and Target Device Query Modes
One of three different modes can each be used for Query Mode (Appliance) and Query Mode
(Target Device):
• Basic – A username and password query for the user is made to the directory service. If
they are verified, the user is given appliance administrator access to the appliance and any
attached target devices for Query Mode (Appliance), or to any selected target device for
Query Mode (Target Device).
64 DSR® Switch Installer/User Guide
To Next Page
Loading...
