Figure 3.17: OSCAR Interface Name Modify Dialog Box
2. Type a name in the New Name box. Names of target devices may contain all printable
characters.
3. Click OK to transfer the new name to the Names dialog box. Your selection is not saved
until you click OK in the Names dialog box.
4. Repeat steps 1-3 for each target device in the system.
5. Click OK in the Names dialog box to save your changes.
-or-
Click X or press Escape to exit the dialog box without saving changes.
NOTE: If an IQ module has not been assigned a name, the EID is used as the default name.
To list target devices alphabetically by name:
Press Alt+N or click Name in the Main dialog box.
Commands Dialog Box Functions
From the OSCAR interface Commands dialog box, you can manage your DSR switching
system and user connections, enable the Scan and Broadcast modes and update your firmware.
Table 3.7: Commands to Manage Routine Tasks for Your Target Devices
Features Purpose
Broadcast
Enable
Begin broadcasting to your target devices. Configure a target device list for broadcasting
under the Setup dialog box.
38 DSR® Switch Installer/User Guide
To Next Page
Loading...
