Figure 4.4: LDAP Search Page in the On-Board Web Interface
To configure LDAP search parameters:
1. Select Appliance - Appliance Settings - User Accounts - LDAP Accounts - Search.
2. Enter the appropriate information in the Search DN, Search Password, Search Base and UID
Mask fields.
3. Click Save.
NOTE: These options cannot be changed if the LDAP Priority is set to LDAP Disabled on the Overview screen.
LDAP Query parameters
On the LDAP Query page, you can configure the parameters used when performing user
authentication queries.
The appliance performs two different types of queries. Query Mode (Appliance) is used to
authenticate administrators and users attempting to access the appliance itself. Query Mode
(Target Device) is used to authenticate users that are attempting to access attached target
devices. Additionally, each type of query has three modes that utilize certain types of
information to determine whether or not an LDAP user has access to an appliance or connected
62 DSR® Switch Installer/User Guide
To Next Page
Loading...
