4. Select a DSRIQ module to view and click the Version button. The DSRIQ Version dialog
box appears.
For more information on loading firmware, refer to Flash Upgrades.
Figure 3.23: DSRIQ Version Dialog Box
5. Click X to close the DSRIQ Version dialog box.
Depending on your DSRIQ module type, you may have the option of switching between USB
2.0 Speed and USB 1.1 Full Speed.
To enable or disable USB 2.0:
1. If the OSCAR interface is not open, press Print Screen to open the Main dialog box.
2. Click Commands - Display Versions to open the Version dialog box shown in Figure 3.21.
3. Click DSRIQ to open the DSRIQ Selection dialog box shown in Figure 3.22.
4. Select a DSRIQ module to view and click the Version button. The DSRIQ Version dialog
box appears.
5. Click Disable to turn off USB 2.0 - and turn on USB 1.1 Full Speed.
-or-
Click Enable to turn off USB 1.1 Full Speed and turn on USB 2.0 Hi Speed.
Resetting your PS/2 keyboard and mouse
NOTE: This function is for Microsoft Windows-based computers only. Resetting the PS/2 on a target device running
any other operating system may require that you reboot that target device.
Chapter 3: Local Port Operation 43
To Next Page
Loading...
