Figure 3.9: OSCAR Interface Screen Saver Dialog Box
To set the Screen Saver options:
1. Type the number of minutes for Inactivity Time (from 1-90) to delay activation of password
protection and the screen saver feature.
2. For Mode, select Energy if your monitor is ENERGY STAR
®
compliant; otherwise select
Screen.
CAUTION: Monitor damage can result from the use of Energy mode with monitors not compliant with ENERGY
STAR
®
.
3. (Optional) Click Test to activate the screen saver test, which lasts 10 seconds, then returns
you to the Security dialog box.
4. Click OK to save your settings.
To exit Screen Saver mode and log in to the local port:
1. Press any key or move the mouse.
2. If OSCAR Authentication has been enabled, you will see a login screen. Enter your
username and password and then click OK. If you do not know your username and
password, contact the DSView 3 software server administrator.
3. The Main OSCAR interface dialog box will appear where you may select any available
target device.
To immediately activate the screen saver:
Press Print Screen, then Pause.
This command sequence works only when the user is connected to a target device.
Chapter 3: Local Port Operation 31
To Next Page
Loading...
