To enable or disable the Ping Response:
1. If the OSCAR interface is not open, press Print Screen to open the Main dialog box.
2. Click Setup - Network to open the Network dialog box.
3. Select either Enabled or Disabled in the Ping Response section.
4. Click OK.
For more information on pinging an IP address, see Sending a ping request on page 44.
Configuring the IP address
The IP Setup dialog box allows users to choose either IPv4 mode or IPv6 mode. The default is
IPv4. You can also specify an IP address for the appliance to use.
To configure the IP address:
1. If the OSCAR interface is not open, press Print Screen to open the Main dialog box.
2. Click Setup - Network to open the Network dialog box, then click Set IP Address... to open
the IP Setup dialog box shown in Figure 3.12.
Figure 3.12: OSCAR Interface IP Setup Dialog Box
3. Select either IPv4 or IPv6.
4. Either select or deselect the DHCP checkbox.
NOTE: If you select the DHCP checkbox, any information that you enter in the IP Address, Prefix/Netmask and
Gateway fields will be ignored.
5. If you deselected DHCP in step 4, type the desired information in the IP Address,
Prefix/Netmask and Gateway fields.
34 DSR® Switch Installer/User Guide
To Next Page
Loading...
