Figure 3.19: OSCAR Interface User Status Dialog Box
To disconnect a user:
1. If the OSCAR interface is not open, press Print Screen to open the Main dialog box.
2. Click Commands - User Status to open the User Status dialog box shown in Figure 3.19.
3. Click the letter corresponding to the user to disconnect. The Disconnect dialog box will
appear as shown in Figure 3.20.
Figure 3.20: OSCAR Interface Disconnect Dialog Box
4. Click OK to disconnect the user and return to the User Status dialog box.
-or-
Click X or press Escape to exit the dialog box without disconnecting a user.
Chapter 3: Local Port Operation 41
To Next Page
Loading...
