- 13 -
Quick Arm
Press (ON) (ON) (ENT) ON Arming: ___________
Note: if the sequence of pushbuttons is pressed on a keypad associated to a sector, that sector
is armed; if it is associated to more sectors, these will be simultaneously armed.
Normal Arming
The display shows the current date and hour
Digit User Code
Note: if the user code is associated to multiple sectors and the “Skip sector selection” option is
not active, you will be asked to select the sector to work in.
The Display shows the system’s current situation.
Press the key that corresponds to the type of Arming desired:
Press (ON) ON Arming: ___________
Contemporary Arming of more sectors
This function is active only for the users enabled to “Sum of Sectors”
The display shows the current date and hour
Digit User Code
The Display shows the system’s current situation.
Digit (0) To enter the mode Sum and in order to contemporarily operate on more sectors.
Press the key that corresponds to the type of Arming desired.
The red ON led will light up to indicate that the unit has been switched on and the arming
mode will show on display.
Macro activation by user code (A and B keys)
You can turn on the sectors associated to the “A-B” keys by simply pressing them after entering
the user code.
The sectors associated to them must be agreed on with the installer during programming and
are linked to the keypad/code performing the operation.
The display shows the current date and time
Digit User Code
Note: if the user code is associated to multiple sectors and the “Skip sector selection” option is
not active, you will be asked to select the sector to work in.
Type the on command A or B
To Next Page
Loading...