- 15 -
Normal Arming with Zone Timers Off
The function “OFF TIMES” allows the User to eliminate the system input and output time, thus
granting max security. In fact, eliminating these time lapses during partial arming will cause an
immediate alarm in case of intrusion attempt, with no risky and unuseful delay.
This function is linked to the conguration of the Macro and should be agreed with the installer
during programming
This function will automatically de-activate at following disarming of the system.
Any procedure of Tempi Off and Tempi On will be visualized in the events memory.
Special Arming (by use of timer)
The automatic arming of the control unit is anticipated by the buzzer signalling on the keypad.
During this signalling, it is possible to make the special arming in order to delay it of one hour.
This operation can be made up to three times, after which the system will not accept any other
special arming and will proceed to arm.
Display will show date and time and buzzer will sound
Digit User Code
Note: if the user code is associated to multiple sectors and the “Skip sector selection” option is
not active, you will be asked to select the sector to work in.
Press on pushbutton (8) key to make special arming.
Activation of the PATROL function
During arming of the system, it is possible to activate the PATROL function, allowing the passage
to an area pre-set as PATROL via a group of detectors previously associated.
These detectors will exclude for a pre-set time lapse and will then re-activate automatically.
According to control panel programming, it is possible to ask for a conrmation of the dialling of
the patrol user-code once the inspection is over.
The PATROL code cannot carry out the functions usually associated to the code.
Display will show date and time and buzzer will sound
Digit User Code
Note: if the user code is associated to multiple sectors and the “Skip sector selection” option is
not active, you will be asked to select the sector to work in.
To Next Page
Loading...