OXYGEN 1000 & OXYGEN 2000 · User Manual · ENG
OXYGEN REMOTER - SETTINGS |MONITORS SECTION
The status of MUTE-SPK-CRM is indicated by the following MUTE label on the bottom-right of the
HDMI display:
D. STUDIO HEADPHONES (HDP-STD)
This section is used for the management of the HDP-STUDIO
headphones 🎧.
The rotary control knobs allow you to amplify/attenuate the audio level.
The headphone audio level goes from 0 to 99 is the maximum allowed
level. Can set the maximum level by going to this page:
MENU / AUDIO / OUTPUTS / MONITOR / HEADPHONES / HDP-STUDIO
The step of the headphone adjustment is 1 dB and the level goes from
-80 dB to the maximum of +19 dB.
By pressing the knob, you can mute or play the HDP-STUDIO
headphones if it is already muted.
To unmute the headphone 🎧 just press their knob or
increase/decrease the audio level by rotating the knob and confirm
that by clicking on the same knob.
The headphone level is displayed in the bottom-right section of the HDMI display.
The status of MUTE-HDP-STD is indicated by the following MUTE label on the bottom-right of the
HDMI display:
To Next Page