How to fix poor rendering of MPEG-4 images on Axis Security Camera?
For poor rendering of MPEG-4 images from your Axis Security Camera, ensure the color depth is set to 16-bit or 32-bit on the clients. If text overlays are blurred or there are other rendering problems, enable Advanced Video Rendering from the MPEG-4 tab in the AMC control panel applet. Also, make sure your graphics card is using the latest device driver.
What to do if the IP address of my Axis 207W Security Camera is being used by another device?
If the IP address is being used by another device, disconnect the Axis Security Camera from the network and run the Ping command. If you receive a reply from the IP address, it means another device is using the IP address. Obtain a new IP address and reinstall the unit. If you see 'Request timed out', the IP address is available. In this case, check all cabling and reinstall the unit.
How to fix no images on Axis 207W Security Camera web page due to AMC in Internet Explorer?
To fix the issue of no images being displayed on the web page due to a problem with AMC (Internet Explorer only) for your Axis Security Camera, enable ActiveX controls in your browser settings. Also, ensure that the AXIS Media Control (AMC) component is installed on your computer.
Why is the frame rate lower than expected on my Axis 207W?
If you're experiencing a lower frame rate than expected with your Axis Security Camera, here are several things to check: * Reduce the number of applications running on the client computer. * Limit the number of simultaneous viewers. * Ensure sufficient bandwidth is available by checking with the system administrator. * In the AMC control panel applet (MPEG-4 tab), verify that video processing is not set to 'Decode only I frames'. * Try lowering the image resolution.
Why is multicast MPEG-4 on my Axis 207W Security Camera only accessible locally?
If multicast MPEG-4 is only accessible by local clients for your Axis Security Camera, check if your router supports multicasting, or if the router settings between the client and the server need to be configured.
What to do if Axis 207W cannot be accessed from a browser after DHCP IP change?
If you cannot access your Axis Security Camera from a browser and the IP address has been changed by DHCP, try these steps: 1) Move the camera to an isolated network or one without a DHCP or BOOTP server, then reset the IP address using the AXIS IP Utility or ARP/Ping commands. 2) Access the unit and disable DHCP in the TCP/IP settings, then return the unit to the main network. 3) Alternatively, if a dynamic IP address via DHCP or BOOTP is required, select the necessary service and configure IP address change notification from the network settings.
Why can't I access my Axis 207W on the wireless network from a browser?
If you cannot access your Axis Security Camera on the wireless network from a browser, it could be due to several reasons. The wireless settings in the camera might not match those in the wireless access point, so connect the network cable and ensure the SSID and security settings are identical in both. Also, check that the wireless access point supports and has enabled at least one of the supported protocols. Finally, the wireless access point may require MAC address registration, so verify if the camera’s MAC address needs to be registered before accessing the wireless network.
General| Camera Type | Network Camera |
|---|---|
| Sensor Type | 1/4" progressive scan CMOS |
| Resolution | 640x480 (VGA) |
| Frame Rate | 30 fps |
| Lens Type | Fixed |
| Aperture | F2.0 |
| Field of View | 54° |
| Video Streaming | Yes |
| Wireless Connectivity | 802.11b/g |
| Security | Password protection, IP address filtering, HTTPS encryption |
| Compression | Motion JPEG |
| Protocols | HTTP, HTTPS, TCP, UDP, RTP, RTSP, SMTP, FTP |
| Audio Support | Two-way audio |
| Power Supply | 5 V DC |
| Operating Conditions | 0°C to 50°C |
To Next Page
