51
Problem Solution
No Picture, no sound 1. Check if the fuse or circuit breaker is working by checking that all the fuses
inside your main fuse box are ON or test the power outlet is working by trying
with another electrical product e.g. a lamp.
2. Make sure your wall socket is switched on and is working properly (to check
this, plug another electrical device into the outlet).
3. Make sure the plug is securely inserted into the outlet.
4. Make sure all connections are secure.
No colour 1. Change the colour system.
2. Adjust the saturation.
3. Try another channel.
4. Check if the program is broadcast in black and white.
Remote control does not work 1. Change the batteries.
2. Check that the batteries are installed correctly.
3. Ensure the TV is connected to the mains power.
No picture, normal sound 1. Adjust the brightness and contrast.
2. Broadcasting may be interrupted.
Normal picture, no sound 1. Press the Volume + button to increase the volume.
2. Press MUTE to restore sound if the volume is set to mute.
3. Change the sound system.
4. Broadcasting may be interrupted.
Pixelation in the picture This is usually caused by local interference from things such as cars,
uorescent lights or hair dryers. Adjust the antenna to minimise the
interference.
Blank screen in PC mode Perhaps the TV cannot recognise the resolution set by the PC. Try setting it to
the best resolution possible, or to another standard Windows resolution. Set
the refresh rate to 60Hz by right clicking with your PC mouse onto your PC
Desktop, select “screen resolution” then select “advance settings” and set the
refresh rate with the “screen refresh rate” drop down menu and press “apply”.
Pixelation If the antenna is located in the fringe area of a television signal where the
signal is weak, the picture may be marred by dots. When the signal is
extremely weak, you may need to install a special antenna to improve the
reception. Other options include:
1. Adjust the position and orientation of the indoor/outdoor antenna.
2. Check the connection of the antenna.
3. Fine tune the channel by selecting the channel into “Channel Setting” and
scroll down to “Fine Tune” to slightly adjust the frequency.
4. Try another channel. Broadcasting may be interrupted.
Pixelation, picture breaking up Black spots or horizontal streaks appear, or the picture utters or drifts. This is
usually caused by interference from a car ignition system, neon lamps, electric
drills or other electrical appliances.
Ghosting (analog TV only) Ghosting is caused by the television signal following two paths: one is the
direct path, the other is reected from tall buildings, hills or other objects.
Changing the direction or position of the antenna may improve the reception.
Radio frequency interfernce
(analog only)
This interference produces moving ripples or diagonal streaks and, in some
cases, loss of contrast in the picture. Identify and remove the radio
interference source.
FAQs
50
Preference Page
- Press the DVD SETUP key and then press to display the preference page when in
DVD mode.
- Press the key to move the highlight to select following option.
- Press the OK key to go into the following menu and then press the key to select a
menu item.
The default password is “123456”.
Off
To Next Page
Loading...
