Axis M3045-V - Basic Setup

AXIS M3045-V Network Camera
Set Up the Product
Set Up the Product
The Axis product can be congured by users with administrator or operator rights. To open the product’s Setup pages, click Setup in
the top right-hand corner of the Live View page.
• Administrators have unrestricted access to all settings.
• Operators have restricted access to settings, see Users on page 46
See also the online help
.
Connect the Camera to a Monitor
When the camera is rst connected to a monitor and then powered up, the default capture mode is automatically set for viewing the
image stream over HDMI. If the camera is connected to a monitor after power up, restart the camera or set the capture mode to
1080p (HDMI)@30/25 fps. This can be done from the Capture mode drop-down list from Video > Camera Settings. This can also be
done from the Congure capture mode window (see Congure Capture Mode on page 10) after a factory default (see page 58).
Note
It is recommended to use only HDMI certied monitors and cables. For more information see www.hdmi.org
Basic Setup
Basic Setup provides shortcuts to the settings that should be made before using the Axis product:
1. Users. See page 46.
2. TCP/IP. See page 49.
3. Date & Time. See page 48.
4. Video Stream. See page 17.
The Basic Setup menu can be disabled from System Options > Security > Users.
16