Axis W100 User Manual

10/19/21, 7:42 PM
AXIS W100 Body Worn Camera User manual
https://help.axis.com/axis-w100-body-worn-camera
17/68
Set up self-assign camera assignment
Note
To set up self-assign camera assignment, you need to pair the body worn user with a self-
assign tag:
How to set up self-assign camera assignment for yoHow to set up self-assign camera assignment for yo……
Set up self-assign camera assignment
Self-assign camera assignment mode is accessed through the system setup wizard,
and is available after a system reset.
The RFID reader required for this setup is External RFID Card Reader 125kHz +
13.56MHz with NFC (USB).
Always install your RFID reader(s) in the same location as your docking stations.
1. Connect the RFID reader to the system controller. Wait for the LED on the reader to light
up green, which takes about 15 seconds. The reader now has the correct firmware and is
ready for use.
2. Disconnect the RFID reader from the system controller.
3. Connect the same RFID reader to the computer that you use for accessing AXIS Body Worn
Manager.
AXIS W100 Body Worn Camera
󰍜

Axis W100 Specifications

General

Brand	Axis
Model	W100
Category	Security Camera
Language	English