Azbil AUR355 - Page 40

34
Chapter 5. Communication Data
Data type Data name Address Access Description Note
Decimal
(W)
Hex
(H)
Read Write
Event (write
only)
UV flame detector check (combustion
time)
7109 1BC5 0 to 61A8H (0 to 25000 hours)

Writing 2-word event
settings (p.38)
The count returns to 0 when
the power is turned on
or after data is written to
EEPROM.
7110 1BC6 0036H
Product service life check (total
operating time)
7111 1BC7 0 to FDE8H (0 to 65000 hours)
7112 1BC8 0037H
Product service life check (total
combustion count)
7113 1BC9 0 to AH (0 to 10 times) The value calculated by
multiplying the data range by
10000 is used to determine
whether an event has
occurred.

Writing 2-word event
settings (p.38)
The count returns to 0 when
the power is turned on
or after data is written to
EEPROM.
7114 1BCA 0038H
Event relay output condition setting 7115 1BC8 405AH: event output
403CH: synchronized with start check
relay
The event output is set up
before the product is shipped.
The count returns to 0 when
the power is turned on
or after data is written to
EEPROM.
EEPROM
write
request
Write AUR settings to EEPROM request 7200 1C20 5AH: request to write data to EEPROM
3CH: writing to EEPROM complete
Writes values from addresses
7100 to 7115 to EEPROM.
After changing a value, be
sure to write it to EEPROM.
After you write values to
EEPROM, the values at
addresses 7100 to 7115
change to 0.
Flame
logger
Flame logger processing status 8000 x 5AH: processing in progress
Other than 5AH: normal
Recorded data 0.1 s after trigger 8100 x Bit 0: undefined
Bit 1: startup input
0: no start input
1: start input
Bits 2 to 3
Undefined
Bit 4: flame input
0: no flame input
1: flame input
Bit 5
Undefined
Bit 6: start check relay
0: OFF
1: ON
Bit 7: flame relay
0: OFF
1: ON
Bit 8
Undefined
Bit 9: shutter (AUR355C only)
0: OFF
1: ON
Bit 10
Undefined
Bits 11 to 13: flame level (AUR355C only)
0 to 5
Bits 14 to 15
Undefined
Recorded data 0.1 s after trigger 8101 x Bits 0 to 7: operating status No. when an
event occurs

Operating status No. table
(p.36)
Bits 8 to 15: flame voltage
0 to 50 [0.1 V]
– – x
Recorded data 10.0 s after trigger 8298 x Address: same as 8100
Recorded data 10.0 s after trigger 8299 x Address: same as 8101
* Settings can also be changed using Smart Loader Package model SLP-A55.