2-3
Chapter 2. MOUNTING AND WIRING
Mounting the controller
The method of mounting the controller on the subbase is described below.
(1) With the controller positioned so that the main unit-subbase screw is near the
bottom, latch the hook on top and then lower the controller so that it meets
the subbase. Push the controller against the subbase so that the terminals make
contact.
(2) Tighten the main unit-subbase screw to secure the controller to the subbase.
The maximum tightening torque of the screw is 0.5 N·m.
(3) Attach the code label to the panel or some other easy-to-see location near the
controller so that when an alarm occurs, it will be easily identifiable.
Dismounting the controller
Remove the main unit-subbase screw first, and then, while holding the subbase, lift
off the controller, bottom first.
To Next Page
Loading...
