Azbil VDC - Assembly

Azbil Corporation Safety Guide
Model MTG11A/18A, MTG11B/18B, MTG14C ix
6 : Assembly
CATUTION
• When assembling the spring loaded
actuator, adhere to the order of
assembly procedure; install bolts
and nuts as instructed. Disregard of
procedure may result in malfunction.
• When installing a buttery valve
on a pipe line, fully close the valve
(vane or disk). Tighten ange bolts
and nuts diagonally and with even
torque.
• When installing the valve body,
always use new gaskets. Old or
reused gaskets may cause leakage
• When assembling trim (inner valve),
ensure that specialized tools are
available and use only those which
meet specications.
Follow assembly procedure
Install buttery valve in fully closed
position
Tighten diagonally
1
2
3
4
Replace packing / gasket
WARNING
• When assembling the valve, tighten
bolts and nuts at a torque as specied
in instruction manual. Any damage
or corrosion on the bolts or nuts may
cause destruction of control valve
which will lead to physical injury.
Always replace defective bolts and
nuts with new ones.