Azbil Corporation Safety Guide
Model MTG11A/18A, MTG11B/18B, MTG14C iii
Compliance with Regulations
This product complies with the directive below.
• Pressure Equipment Directive (PED) 2014/63/EU
Requirements for workers (installation, operation, maintenance)
To ensure safety, only specialists who are skilled in instrumentation work should
carry out the installation, operation, and maintenance of this device.
Cautions on storage
When storing the control valve, pay attention to the following precautions:
• A control valve that has been packed in a cardboard box should be stored indoors
at normal temperature and humidity.
• A control valve that has been packed in a wooden crate should be stored indoors
at normal temperature and humidity as a rule. In the event outdoor storage, open
the crate, verify the specications of the unit and cover it with a polyethylene
protective sheet to guard against precipitation.
• When storing a used valve, follow the procedures described below:
(1) Flush out the process uid from inside the valve body and dry,
(2) When there is a possibility of the valve body rusting, preservation treatment
should be given,
(3) To prevent water from getting into the instrument, cover pneumatic tubing
connection and electric connector with watertight caps or tape. Also, protect
the connector threads,
(4) Place a ange cap onto the end of the pipe connecting surface (ange face,
butt welding connections) to avoid any possible damage.
To Next Page
Loading...
