Maintenance
Charging the racket
Charging your battery can be done at any time. To do this, you can either use a USB port on
a computer with the USB cable provided, or by plugging the USB cable into a wall plug
equipped with a USB port. It will take 3 hours to fully charge your battery.
Caring for your BABOLAT PLAY racket
It is not advisable to use your PLAY racket when it’s raining heavily. Never put your BABOLAT
PLAY racket in water. It will damage the electronic circuitry and sensors.
Avoid dropping the racket on hard surfaces. This could affect the accuracy of the electronic
circuitry inside.
Avoid opening the butt cap trap on a clay court; dust may enter the USB port which could
interfere with its proper functioning.
Avoid extreme temperatures, don’t store your racket in direct sunlight (on the back shelf of a
car for example) or in below 0°C/32°F.
Customization
Do not attempt to open the handle of your racket in order to carry out customization. You
can however add lead tape to the head of your racket in order to change its weight.
Note: Power is calculated on the basis of the speed of the racket head. Adding weight to the
racket could slow down the calculation of the racket head speed.
Updating BABOLAT PLAY application
When the BABOLAT PLAY app update is available, a message will appear on your mobile
device. Click-on the BABOLAT PLAY app icon on your mobile to start the updating process of
the software.
Updating BABOLAT PLAY software
When BABOLAT connect software updates are available, a message in the software will say,
“A newer version of BABOLAT connect software is available, would you like to download and
install it now?” Clicking the update button will update the software.
Updating BABOLAT PLAY racket
Each time you plug your BABOLAT PLAY racket into the USB port on your computer or
connect to your mobile app via Bluetooth, BABOLAT PLAY will check for new firmware
(updates for your BABOLAT PLAY racket). When new updates are available, a message in
BABOLAT connect will prompt you to accept the update.