BOSS Saw User Manual V1.0
5/9/2019
7. To apply straight cuts, there are 2 different options.
a. Automatic
i. this will apply all exterior and interior cuts that have
NOT been already processed
b. Manual
i. this will allow to place just the cuts you want to process.
ii. When selecting, blue arrows should point to the right or
down.
8. There are 3 options to complete on finished cuts.
a. Offset machining
i. This allows to select an already determined cut and
offset it a distance of your choosing.
ii. this is the fastest and less waste full option. Will require
you to break the final pieces apart with a pry bar.
b. MILL CORNER
i. This is the longest running and most dangerous process.
Requires a 1” minimum between parts
c. DRILL CORNER
i. Depending on the size of your core bit, you may have to
apply multi holes too free the piece. This option
requires the most distance between parts.
9. If cuts are short. Like on a back wall, see EXTEND CUTS.
Dashed yellow line is on the INSIDE of the
piece.
To Next Page
Loading...