BOSS Saw User Manual V1.0
5/9/2019
SAFETY
This section contains safety instructions that must be followed to ensure safe operation, loading/unload, and
maintenance of the equipment. Everyone operating the equipment must read and understand these precautions before
operating the equipment. OSHA and state safety agency rules must be complied with in addition to those given in the
safety section and elsewhere in this manual. Applicable plant general safety practices must also be followed.
BACA Systems designed your BOSS Saw with safety in mind. Throughout this manual, safety precautions and warnings
are highlighted for specific operations. Safety precautions are also posted on the equipment. Operator and service
personnel shall pay attention to these cautions at all times.
On-site safety and engineering personnel should develop and maintain proper work instructions for this machine which
incorporate general and specific safety instructions as found in this manual.
On-site safety and engineering personnel should develop and maintain proper lockout/tagout procedures for this
equipment following applicable local requirements. If unsure of these requirements you should contact your state or
federal OSHA representatives.
Make a routine daily inspection of the entire machine before operating it. Visually check all parts of the machine for
abnormal condition. If any issue is noted report it immediately to your supervisor for immediate correction.
To Next Page
Loading...