Fyrite
InTech
Manual Setup
0024-9486 Rev 2 15
2.3. Power Options
You use the PWR button to turn on the Fyrite
InTech
. Power options
include:
• Disposable AA alkaline batteries (included)
• Disposable AA lithium (Li) batteries
• Externally charged rechargeable NiMH batteries.
Check the Fyrite
InTech
for sufficient power prior to each use. Replace the
batteries if the low (or replace) battery symbol appears in the upper right
corner of the Fyrite
InTech
screen.
Batteries (4 AA, Fresh or Fully Charged)
Estimated Life Span in Hours
(Continuous, Pump On)
Alkaline (disposable) 15 hours
Lithium (disposable) 20 hours
Rechargeable 8 hours
Replace batteries as follows.
1. Remove the battery cover from the back of analyzer.
2. If old batteries are installed, remove them and properly discard them.
3. Observing the polarity markings inside the battery compartment,
install four ‘AA’ disposable (alkaline or lithium) batteries or four fully-
charged (externally charged) AA rechargeable NiMH batteries.
4. Replace the battery cover.
NOTE: The Fyrite
InTech
To Next Page
Loading...
Need help?
General
