microLAN b.v. BACTcontrol – Software Manual – V1.15 Page 19 of 28
8. SETTINGS
In the Settings menu process parameters and settings can be changed.
Make sure you change the correct parameter.
Changing the default settings may affect the measurement process or
can damage some components of the BACTcontrol!
Settings can only be changed when system is not “Busy” !
8.1 SEQUENCE
In the submenu Sequence, different parameters, such as temperature, stabilisation
time, incubation time, Volumes, conversion factor and filtration volume can be
changed. (When changing these settings, please contact microLAN for advice)
By clicking a blue selection button the assigned pump can be chosen.
Figure 14 Sequence screen
8.2 CYCLE
In the submenu Cycle the settings for the different measurements can be changed.
To Next Page
Loading...
