BACTcontrol microLAN - Sample Inlet, Outlet, and Waste Connection

Page 26 of 28 BACTcontrol – Software Manual – V0.1.15 microLAN b.v.
9. SERVICE
In the service menu manual operating actions and advanced pump and valve settings
can be activated or changed.
Pump and valve numbers are mentioned in the figure below.
Figure 19: scheme of BACTcontrol system
9.1 ACTIONS
In the Actions menu operating actions for a first start-up of the system or
flushing after maintenance can be activated. Also bottle volumes can be reset.
 Fill Inlet System: Selecting this button will fill the inlet probes of the system.
(after replacing tubes or when air is accumulated in the inlet system)
 Fill Cleaning Probe: Selecting this button will refill the cleaning probe
(can be selected after replacing the cleaning bottle)
 Fill P2 Probe: Selecting this button will refill the probe of the left reagents
pump
 Fill P3 Probe: Selecting this button will refill the probe of the middle reagents
pump
 Fill P4 Probe: Selecting this button will refill the probe of the right reagents
pump
 Cleaning: Selecting this button will start a Cleaning (this will abort a running
measurement!)