Bad Boy 4035CH 2021 - Checking and Changing Coolant; Checking and Adding Fuel

6
-
9
MAINTENANCE
6
1. To drain coolant, open the radiator
cap and drain plug and drain cool-
ant completely from the radiator.
2. Flush the radiator until clean water
is drained.
3. Add coolant up to the ller neck of
the radiator.
4. Start and operate the engine for 5
minutes after filling the reservoir
tank with coolant up to the “FULL”
level. At this time, press the heat-
er switch of the air conditioner to
activate the heater. Stop the en-
gine and check if the coolant level
is between the “FULL” and “LOW”
marks. If not, add some coolant as
needed.
REPLACEMENT PROCEDURE
CHECKING AND CHANGING COOLANT
CHECKING
Open the hood and check if the cool-
ant level in the reservoir tank is be-
tween the "FULL" and "LOW" marks.
Add coolant through the ller if nec-
essary.
(1) Coolant reservoir tank
(A) FULL (B) LOW
CHECKING AND ADDING FUEL
Turn the main switch to the "ON" posi-
tion. If the fuel gauge needle is point-
ing the red area, open the fuel cap,
and then fill the fuel tank full through
the oil ller. And check if there is leak-
age.
(1) Fuel cap
•
Never smoke or use a lighter
while refueling the tractor.
•
After refueling, securely close
the fuel cap and wipe off any
spilled fuel.
DANGER
4035ch.indb 94035ch.indb 9 2020-09-18 오후 6:29:212020-09-18 오후 6:29:21