4
-
8
BAD BOY TRACTOR
1. When the machine has reached
the desired speed, press cruise
control switch to “ON”. Release
the HST pedal and the machine
will operate at the selected speed.
2. When applying full pressure to the
Brake pedals, the cruise control
will be deactivated and it will be
necessary to reset the cruise con-
trol to the desired speed.
3. When applying light pressure to
the Brake pedals, the machine’s
ground speed will be reduced until
the Brake pedals are released. At
that point the machine will contin-
ue at the previous setting.
4. To reset the desired speed, you
should turn off the cruise con-
trol switch then increase machine
speed to reach the desired speed
push cruise switch to on.
CAUTION
When stopping the machine
cruise control keep machine
stop status.
Make sure to connect both
Brake pedals when using
cruise control function.
[Otherwise]
There is a risk abrupt turning
or overturning due to one-sided
Braking when the Brake pedal is
depressed.
CRUISE CONTROL SWITCH
(1) Cruise Control Switch
(2) Brake Pedal
4035ch.indb 84035ch.indb 8 2020-09-18 오후 6:29:152020-09-18 오후 6:29:15
To Next Page
Loading...
