Bad Boy 4035H 2021 - Daily Inspection before Starting; Pre-Operation Check; Pre-Operation; Before Starting the Engine

5
-
2
BAD BOY TRACTOR
DAILY INSPECTION BEFORE
STARTING
BEFORE STARTING THE ENGINE
1. Check the engine oil level.
After wiping out the dipstick, insert
it fully and then withdraw it. Oil
should be between the two marks
on dipstick.
Do not operate the engine if oil
level is below minimum mark. If
below, add the corresponding
grade oil according to the season
through the ller.
2. Feed grease to all greasing points
indicated below every 10 hours
when working in damp and muddy
conditions.

Front axle pin

Steering shaft and Cylinder end

Tie rod both ends

Front axle supporter
3. After cleaning the machine with
highly pressurized water, lubricate
the indicated points with grease
below if necessary.

Bonnet latch

Seat sliding rail
PRE-OPERATION CHECK
PRE-OPERATION
Check the engine operation carefully.
IMPORTANT
•
The engine is tuned or set for
normal use. In case of a new
tractor, especially carry out in-
spection and check within rst
100 hours.

Be sure to warm up the engine. In-
spect the battery charge warning
lamp, oil pressure warning lamp
and engine coolant temperature
gauge.

Avoid any unnecessary engine
idling.

Frequently check the engine oil,
coolant, transmission fluid and
front axle oil levels. Also, inspect
for leakage of those uids.
•
Make sure to add the corre-
sponding grade oil for the
season. Use only genuine oil
specied by BAD BOY.
NOTE
CAUTION
•
Avoid running the engine in
an enclosed area. Exhaust gas
can be very harmful to your
health. If it is unavoidable to
run the engine in an enclosed
area, extend the exhaust pipe
to the outside to release ex-
haust gas to the atmosphere.
4025h_4035h.indb 24025h_4035h.indb 2 2020-09-18 오후 6:23:162020-09-18 오후 6:23:16