4 - 33
OPERATION DESCRIPTION
4
3. When applying light pressure to the
Brake pedals, the machine’s ground
speed will be reduced until the Brake
pedals are released. At that point the ma-
chine will continue at the previous set-
ting.
4
. To reset the desired speed, you should
turn o the cruise control switch, then in-
crease machine speed to reach the de-
sired speed and push the cruise switch
to on.
When stopping the machine cruise
control keep machine stop status.
Make sure to connect both Brake ped-
als when using cruise control function.
[Otherwise]
T
here is a risk abrupt turning or over
-
turning due to one-sided braking when
the Brake pedal is depressed.
CAUTION
DPF REGENERATION SWITCH
(1) DPF Regeneration Switch
The DPF (Diesel Particulate Filter) collects
soot contained in the engine exhaust and
reduces exhaust smoke. The soot collect-
ed in the filter must be burned periodical-
ly to prevent the lter from clogging and to
ensure
that the lter can continue collecting
soot. The DPF is regenerated by increasing
the back pressure in the engine and raising
the temperature of the exhaust.
Holding the button down for more than 3
seconds initiates regeneration; the lamp
turns o in 30 minutes when automatic re
-
generation is complete.
BBT 5045, 5055(CS,CH,S,H)_US_.indb 33BBT 5045, 5055(CS,CH,S,H)_US_.indb 33 2024-05-09 오전 9:04:092024-05-09 오전 9:04:09
To Next Page
