To Next Page
L
Lawrence DavisSep 13, 2025
How to disable Err: Simulation on Badger Meter M Series?
- TThomas GuerreroSep 13, 2025
To disable an "Err: Simulation" error, disable the simulator in the I/O menu. This error indicates that the I/O simulator is enabled.
How to disable Err: Simulation on Badger Meter M Series?
To disable an "Err: Simulation" error, disable the simulator in the I/O menu. This error indicates that the I/O simulator is enabled.
General| Sizes | 2" |
|---|---|
| Maximum Continuous Flow Rate | Varies by size |
| Flow Range | Varies by size |
| Output | Pulse |
| Communication | AMR/AMI (optional) |
Provides an overview of the M-2000 flow meter's intended use and basic components.
Details on selecting appropriate sites and aligning the meter for optimal performance.
Precautions for installing the meter in various piping configurations and fluid conditions.
Critical safety guidelines for electrical connections to prevent hazards and damage.
Details on setting up analog signal outputs for flow rate and other parameters.
Procedures for configuring digital inputs and outputs for various functions.
Explains the different display types and how to navigate menus for programming.
Instructions for setting administration, service, and user personal identification numbers.
Guide to configuring flow rate units for measurement.
Guide to configuring totalizer units for measurement.
Overview of main menu options for meter configuration and calibration.
Setting the threshold below which flow measurement is forced to zero.
Configuring the meter for uni-directional or bi-directional flow measurement.
Parameters for configuring the analog output range and alarm modes.
Configuration options for digital inputs and various digital output functions.
Settings for totalizer display updates.
Settings for backlight behavior.
Explanation of various system counters used for performance diagnostics.
Instructions for cleaning the flow tube and electrodes based on fluid contact.
Guidance on diagnosing and resolving common display and measurement inaccuracies.
