Introduction 2-1MN1917
2.1 Features
The Flex+Drive
II
demonstration unit combines a Flex+Drive
II
, a brushless servo motor and an input/output control
panel. Features include:
H Single axis AC brushless drive with integrated Mint controller
H Direct connection to 115VAC or 230VAC single-phase (model dependent)
H Programmable in Mint
H Position, velocity and current control, preset and point to point moves, and gearing
H Auto-tuning wizard (including position loop) and software oscilloscope facilities
H 8 optically isolated digital inputs
H 3 optically isolated digital outputs
H 1 general-purpose analog input (can be used as a speed or torque command reference)
H 1 control relay
H Flash memory for program storage (16k)
2.1.1 Upgrade kits
If you have obtained an upgrade kit (FPHKIT/115 or FPHKIT/230), go straight to Appendix A for instructions on
installing the upgrade components.
2 Introduction
2
To Next Page
Loading...
