Care2
Installation Instructions
Care2 issue 7 ix
!
WARNING
Always ensure that this equipment is correctly earthed by
connection to an AC mains supply with a protective earth
connection.
WARNING
Voltages in excess of 30V RMS AC or 50V DC are considered
Hazardous and in certain circumstances can be lethal.
This product contains wiring and terminations that are energised
to 230V RMS AC mains.
WARNING
If Functional Testing, Maintenance, or Repair is to be completed
with the Mains Power (and/or battery backup) connected then this
should only be undertaken by personnel who are fully aware of the
danger involved and who have taken adequate precautions and
training.
Terminals marked with the "High Voltage" symbol are considered
hazardous and the external wiring connected to these terminals
requires installation by suitably trained personnel.
WARNING
Note that this equipment uses battery backup, and if the Mains
Supply is disconnected Hazardous voltages will still be accessible
on the terminals marked with the "High Voltage" symbol.
!
WARNING
Always replace blown fuses with the correct type and rating.
If a fuse continues to blow further investigation is required.
!
WARNING
The 24V DC batteries used within this system can deliver
extremely high currents that can cause burns or fire.
Care should be taken to ensure tools or jewelery etc are
prevented from causing a Short Circuit.
CAUTION: ELECTRO-STATIC SENSITIVE DEVICES
This product contains Electro-static Sensitive Devices.
Observe the relevant precautions for the protection of ESDs
when handling this equipment.
www.acornfiresecurity.com
www.acornfiresecurity.com
To Next Page
