Baldwin Boxall C2CFPE - Setting Alternate TCP;IP Configuration - Windows 7

Care2
Installation Instructions
66 Care2 issue 7
5.3.3 Setting Alternate TCP/IP Configuration -
Windows 7
1. Open the Windows 7 Control Panel and open the Network
and Sharing Centre window:
Figure 5.16 — Typical Windows 7 Network and Sharing Window
2. Click on “Change Adapter Settings” (as shown in Figure 5.16
above) and the Network Adaptors installed on the PC will be
displayed.
3. Double click on the Local Area Connection icon.
Figure 5.17 — Local Area Connection Icon
4. The status of the Local Area Network will be displayed.
Select “Properties” as shown below.
Figure 5.18 — Local Area Network Connection Status
5. The Local Area Connection Properties will then be
displayed. Highlight Internet Protocol Version 4 (TCP/IP)
and then select Properties (don’t un-check the tick).
www.acornfiresecurity.com
www.acornfiresecurity.com