Need help?Do you have a question about the Balluff BNI EIP-50 105-Z015 Series and is the answer not in the manual?
General| Ripple max. | 10 % |
|---|---|
| EtherNet/IP | Yes |
| Number of ports | 2 |
| Port Type | RJ45 |
| EtherNet/IP Device Level Ring (DLR) | Yes |
| Web server | Yes |
| IO-Link | Yes |
| IO-Link ports | 4 |
| IO-Link revision | 1.1 |
| Interface | Ethernet/IP, IO-Link |
| Operating temperature | 0...55 °C |
| Storage temperature | -25...70 °C |
| Protection type | IP67 |
| Housing material | Die-cast zinc, GD-Zn |
| Product Type | Control Unit |
| Protocol | EtherNet/IP |
| Protection Class | IP67 |
| Rated operating voltage Ue DC | 24 V DC |
| Input voltage low | ≤ 5 V |
| Series | BNI EIP-50 |
| Transmission Rate | 100 Mbps |
Lists OMRON and Balluff devices relevant to the guide's procedures.
Details the specific hardware components and their models used for connection setup.
Specifies IP addresses and subnet masks for Controller and Network Module.
Maps Controller output/input data to Network Module global variables.
Defines sets of tags for output and input data links between devices.
Provides a high-level overview of the connection process steps.
Details the hardware and parameter setup for the Balluff Network Module.
Guides through setting up the OMRON Controller using Sysmac Studio.
Explains how to configure EtherNet/IP tag data links using Network Configurator.
Describes methods to verify the EtherNet/IP connection and data transfer.
Details the process of clearing and re-initializing the controller's memory.
To Next Page
