5．Applicable Devices and Device Configuration
Precautions for Correct Use
Note that the EDS file specified in this Clause 5.2. is not compatible with versions of the
Network Module earlier than "H5_S[].[]". You need the EDS file with a different version that is
compatible with earlier versions of the Network Module.
Precautions for Correct Use
When there is an icon file specific to the device, the icon file and the EDS file must be stored
in the same folder.
Precautions for Correct Use
Update Sysmac Studio and Network Configurator to the versions specified in this Clause 5.2.
or to higher versions. If you use a version higher than the one specified, the procedures and
related screenshots described in Section 7. and the subsequent sections may not be
applicable. In that case, use the equivalent procedures described in this guide by referring to
the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) and Network Configurator
Online Help.
For specifications of the switching hub power supply, refer to the Switching Hub W4S1-series
Users Manual (Cat. No. 0969584-7).
For specifications of the Module / sensor and Actuator power supplies, refer to the BNI
EIP-508-105-Z015 IP67 Modules 8 IO-Link/In-/Outputs, 8 In-/Outputs User's Guide (893539).
The system configuration in this guide uses USB for the connection between the personal
computer and the Controller. For information on how to install the USB driver, refer to A-1
Driver Installation for Direct USB Cable Connection of the Sysmac Studio Version 1
Operation Manual (Cat. No. W504).
For NX1P2 Controllers, there is no need to install the USB driver because they do not have a
USB port.
The NX1P2 Controller, if used, should be connected to your personal computer with an
Ethernet cable. For information on how to connect the cable, refer to 6-2 Going Online with a
Controller of the Sysmac Studio Version 1 Operation Manual (Cat. No. W504).
To Next Page
Loading...
Need help?
General
