66
1.13 GenICam and advanced features
1.13.1 Introduction
In wxPropView (p. 65), you can see them in "Setting -> Base -> Camera -> GenICam":
Figure 1: wxPropView - GenICam controls (depends on device and FW version)
As you can see, there are some controls with and without the prefix "mv".
• "mv" prefix features are unique non-standard features developed by MATRIX VISION.
• Without "mv" are standard features as known from the Standard Feature Naming Convention of GenICam
properties (p. 121) (SFNC).
All those features are "camera based / device based" features which can also be accessed using the camera with
other GenICam (p. 113) compliant third-party software.
Note
Do not mix up the camera based / device based features with the features available in "Setting -> Base
-> Image Processing". Theses features are driver based features which are processed by the software
and therefore need CPU load.
1.13.2 Device Control
The "Device Control" contains the features like
MATRIX VISION GmbH
To Next Page
Loading...
