1.13 GenICam and advanced features 69
1.13.4 Acquisition Control
The "Acquisition Control" contains features like
Feature name (acc. to SFNC
(p. 121))
Property name (acc. to mvIMPACT
Acquire (p. 119))
Description
AcquisitionMode acquisitionMode Sets the acquisition mode of the
device. The different modes con-
figures a device to send
• exactly one image ("←-
SingleFrame"),
• exactly the set number of
frames ("MultiFrame") or
• images constantly until an
application explicitly stops
the acquisition again ("←-
Continuous").
and can be used for asyn-
chronously grabbing and sending
image(s). It works with internal
and external hardware trigger
where the edge is selectable. The
external trigger uses Image←-
RequestTimeout (ms) to time
out.
• The chapter "How To See
The First Image" in the
"mvIMPACT Acquire SDK
GUI Applications" man-
ual shows how to acquire
images with wxPropView
(p. 65).
• The use case Acquiring a
number of images (p. 123)
shows how to acquire a num-
ber of images; also triggered
externally.
AcquisitionStart acquisitionStart Starts the acquisition of the device.
AcquisitionStop acquisitionStop Stops the acquisition of the device
at the end of the current Frame.
AcquisitionAbort acquisitionAbort Aborts the acquisition immediately.
MATRIX VISION GmbH
To Next Page
Loading...
