Balluff MATRIX VISION mvBlueNAOS - User Set Control

82
1.13.13 User Set Control
The "User Set Control" contains features like
Feature name (acc. to SFNC
(p. 121))
Property name (acc. to mvIMPACT
Acquire (p. 119))
Description
UserSetSelector userSetSelector Selects the feature user set to load,
save or configure.
UserSetLoad[UserSetSelector] userSetLoad Loads the user set specified by
UserSetSelector to the device and
makes it active.
UserSetSave[UserSetSelector] userSetSave Endianess of the device registers.
UserSetDefault userSetDefault Selects the feature user set to load
and make active when the device is
reset.
related to the User Set Control to save and load the user device settings.
The camera allows the storage of up to four configuration sets in the camera. This feature is similar to storing
settings in the registry but this way in the camera. It is possible to store
• exposure,
• gain,
• AOI,
• frame rate,
• etc.
permanently. You can select, which user set comes up after hard reset.
Use case related to the "User Set Control" is:
• Creating user set entries (p. 186)
Another way to create user data is described here: Creating user data entries (p. 184)
MATRIX VISION GmbH