B Spanner for mounting/dismounting
Probes, standard horns and booster horns are highly-sensitive parts that must be mounted and
dismounted with the greatest care.
For this reason, only use the following spanners for mounting/dismounting of probes from standard
or booster horns, as well as of standard or booster horns from the ultrasonic transducer:
Spanner
Type
Use
Spanner SW 10
Part of scope of supply.
To mount/dismount probes
MS 72, MS 73,
KE 76, TT 13 and TT 13 F
chapter 4.3.1 as well as probe
extension VS 70
Spanner
Not supplied by BANDELIN.
To mount/dismount titanium
plates TT 19 and TT 25
SW 15 for TT 19
SW 17 for VS 190 T
SW 22 for TT 25 chapter
4.3.1 as well as probe
extension VS 200
Sickle spanner HS 40/42
Part of the scope of supply of the homogeniser.
To mount/dismount all probes
(used to hold the standard or
booster horn fi rmly in place)
chapter 4.4
Sickle spanner HS 40/42, long
2 units are part of the scope of delivery of an additionally-
ordered standard or booster horn.
For mounting/dismounting of
standard and/or booster horns
from the ultrasonic transducer
Chapter 4.4
To Next Page
