10.2.3 Receiver Status Indicator Operation - Trip Output
Operating Mode Reset Indicator Status Indicator Zone Indicators 7-Segment Diagnostic Display OSSD Outputs
Power-up Off Single-Flash Red All Single-Flash Red
Scan code flashes 3 times - sequentially
C1 Ox or C2 Ox where x is the selected
mute configuration.
Off
Alignment Mode -
Beam 1 Blocked
Off Red
Zone 1 Red, Others
Off
CH1 Off
Alignment Mode -
Beam 1 Clear
On Red Red or Green Total number of blocked beams Off
Run Mode - Clear On
Solid Green or Flashing
Green
13
All On Green - On
Run Mode -
Blocked
On Red Red or Green Total number of blocked beams Off
Lockout Off Flashing Red All Off
Displays error code (see
Troubleshooting
(p.
76))
Off
10.2.4 Receiver Status Indicator Operation - Latch Output
Operating Mode Reset
Indicator
Status Indicator Zone Indicators
14
7-Segment Diagnostic Display OSSD Outputs
Power-up
Off Single-Flash Red All Single-Flash Red Scan code
flash 3 times - sequentially
C1 Ox or C2 Ox where x is the selected
mute configuration
Off
Alignment Mode -
Beam 1 Blocked
Off Red Zone 1 Red
14
,
Others Off
CH1 Off
Alignment Mode -
Beam 1 Clear
On Red Red or Green Total number of blocked beams Off
Alignment Mode - All
Beams Clear
Double-Flash Red All On green Off Off
Run Mode - Clear On Solid Green or
Flashing Green
15
All On Green L On
Latched - Blocked
Beam 1 Blocked
On Red Red or Green
14
CH1 Off
Latched - Blocked
Beam 1 Clear
On Red Red or Green
14
Total number of blocked beams Off
Latched - Clear Flashing Red All On Green L Off
Lockout Off Flashing Red Off Displays error code (see
Lockout
Conditions
(p. 76))
Off
12
If beam 1 is blocked, Zone indicators 2–6 will be Off, because beam 1 provides the synchronization signal for all the beams.
13
Flashing if Reduced Resolution is enabled (except the first).
14
If beam 1 is blocked, indicators 2–6 will be Off, because beam 1 provides the synchronization signal for all the beams.
15
Flashing if Reduced Resolution is enabled.
EZ-SCREEN Low-Profile System with Integral Muting
72 www.bannerengineering.com - Tel: + 1 888 373 6767