Banner EZ-SCREEN LPM Series - Contactors; External Keyed Reset Switches; Snap-On Lens Shields

To Next Page

To Previous Page

13.3 Contactors

The normally closed contacts are used in an external device monitoring (EDM) circuit. If used, two contactors per EZ-

SCREEN LPM System are required. See datasheet p/n

111881

for additional options and more information.

Model Description

11-BG00-31-D-024 10 amp positive-guided contactor, 3 N.O., 1 N.C.

BF1801L024 18 amp positive-guided contactor, 3 N.O., 1 N.C. (N.C. contact rated at 10 amps)

13.4 External Keyed Reset Switches

Model Description

EZA-RR-1

External normally open reset switch with 8-pin M12/Euro-style QD; can be interconnected using cordset models QDE-8..D,

DEE2R-8..D, or CSB-..M1281.

MGA-KSO-1 Panel-mount keyed normally open reset switch

MGA-K-1 Replacement key for switch MGA-KSO-1

13.5 Snap-On Lens Shields

Impact-resistant copolyester lens shields snap easily over entire length of sensor housing, protecting against metal cutting

ﬂuids

and other chemicals. The lens shields are not sealed at the top and bottom, and decrease sensing range by

approximately 15% when they are protecting both the emitter and receiver. Order one per sensor.

Sensor Model Lens Shield Model

SLP..-410.. LPSS-410

SLP..-550.. LPSS-550

SLP..-690.. LPSS-690

SLP..-830.. LPSS-830

SLP..-970.. LPSS-970

SLP..-1110.. LPSS-1110

SLP..-1250.. LPSS-1250

EZ-SCREEN Low-Proﬁle System with Integral Muting

www.bannerengineering.com - Tel: + 1 888 373 6767 89