Model Description
LPA-MBK-15
• End-cap bracket for mounting EZ-LIGHT indicators with a 30
mm mounting hub
• Uses end-cap plates and die-cast zinc end cap from bracket
LPA-MBK-11 (supplied with sensor)
• 360º sensor rotation; 14 ga. (1.9 mm) steel, black zinc plated
• End-cap bracket kit includes 1 end bracket
LPA-MBK-16
• Side-mounting bracket provides a mounting option that is fully
adjustable (lateral and +15/-20° rotational) from the face of the
sensor and allows "no blind zone" mounting with minimal or
no "gaps" in detection
•
Zinc diecast
• Includes 1 bracket and hardware
LPA-MBK-20
• Universal adapter bracket for mounting to engineered/slotted
aluminum framing (for example, 80/20
™
, Bosch)
• Retrofit for Banner MS/US/MG; clearance for M4 and M6
hardware
•
Use with LPA-MBK-11, -12, or -13
• 12 ga (2.66 mm) steel, black zinc plated
• Includes 1 bracket and hardware
LPA-MBK-22
• End-cap bracket for mounting sensor inside Unistrut
®
metal
framing; uses end-cap plates from bracket LPA-MBK-11
•
Fits Unistrut P1000 size, with M6 or 1/4" channel nuts
• 14 ga (1.90 mm) steel, black zinc plated; diecast zinc clamps
• Includes 2 brackets and hardware
LPA-MBK-Pxxx
• L-shaped bracket for one emitter or receiver protects sensor
from weld flash, impact.
•
Sized to match sensor length; replace “xxx” in model number
with sensor size (for example, LPAMBK- P270 for use with
sensor SLP..-270..); bracket studs mate with side-mount
brackets LPA‑MBK‑12, included with sensor. Corner notch
accommodates cable routing.
• +10°/ −30° sensor rotation
• 12 ga (2.66 mm) steel, black zinc plated or painted
• Includes 1 bracket and hardware
EZ-SCREEN Low-Profile System with Integral Muting
www.bannerengineering.com - Tel: + 1 888 373 6767 93
To Next Page
Loading...