11 Product Support and Maintenance
11.1 Update the Firmware
1. Download the updated
firmware from Banner Engineering's website.
2. Launch the SX5soft software.
3. Select New Configuration.
4.
Enter Discovery mode and select an online scanner.
5. Click Scanner on the menu and choose the firmware update option.
6.
Enter the device password (default password is admin).
7. In the Firmware update (Package) section, click on ZIP Archive to search for and select the downloaded firmware.
8. Click Load (Configuration Upload).
During the
firmware update, the device is offline.
9. After the firmware
loads, enter Offline-Test mode to create a configuration and test the new firmware.
10. If the firmware is compatible with the device (the configuration is correct with no failures), click Accept (Validation). If
the
firmware is not compatible, click Reject.
11.2 Handing the Scanner
Observe the permissible environmental conditions for storage and operation. The Scanner’s front screen must be clean, free
of damage. and properly installed.
•
Avoid touching the front screen.
• Clean dirty screens immediately.
The SX5's IP protection is guaranteed only when M12 cables or dust covers are installed on the connectors. Only operate,
transport, and store the scanner with its installed cables or dust covers.
11.3 Cleaning the Screens
Clean the SX5’s front and scatter screens regularly, at a frequency depending on the surrounding environmental conditions,
and using the recommended materials. Use only the cleaning kit
specified, consisting of approved cleanser and cleaning
cloths.
Do not use scouring pads or cloths that can cause scratching (e.g., paper towels). Never use solvents that can damage the
plastic materials. The cleaning procedure depends on the type and degree of contamination.
Contamination Cleaning Method
Particles, loose, scouring Vacuum without touching or blow away softly, oil-free; or wipe free in one swipe with cleaning cloth
Particles, loose, non-scouring Vacuum without touching or blow away softly; or wipe free in one swipe with cleaning cloth
Particles, sticking Wet with cloth soaked in cleanser; or wipe free in one swipe with cleaning cloth
Particles, statically charged Vacuum without touching; or wipe free in one swipe with cleaning cloth soaked with cleanser
Particles/drops, smearing Wet with cloth soaked in cleanser and wipe free in one swipe with cleaning cloth
Water drops Wipe free in one swipe with cleaning cloth
Oil drops Wet with cloth soaked in cleanser and wipe free in one swipe with cleaning cloth
Fingerprints Wet with cloth soaked in cleanser and wipe free in one swipe with cleaning cloth
11.4 Replace Your Scanner
If it is necessary to replace your SX5, replace the SX5 with the same model and install it in the same position and alignment
as the original SX5.
1.
Remove all power from the SX5 and the guarded machine.
SX5 Safety Laser Scanner
90 www.bannerengineering.com - Tel: +1.763.544.3164
To Next Page
Loading...
