Barco CSE-200

Other manuals for Barco CSE-200

Installation Manual83 pages

Manual15 pages

Questions and Answers:

J
Jennifer WhitakerSep 8, 2025
What to do if nothing is shown on the Barco CSE-200 Projector Accessories displays at all?
- E
  Emily HarrisonSep 9, 2025
  If nothing is shown on the displays, first ensure that the displays are switched on. Check that the display cable is correctly connected to both the display and the Base Unit. Also, the display might not recognize or be able to display the Base Unit output resolution, so change the corresponding setting via the web interface. Finally, the Base Unit might be in standby mode; briefly push the standby button on the Base Unit or insert a button and run the ClickShare software.
G
gsmithSep 12, 2025
How to resolve Web Interface errors in the processes “WiFi Access Point Daemon” and/or “DHCP Server” on Barco CSE-200 Projector Accessories?
- A
  Angela MillsSep 12, 2025
  If the Web Interface shows an error in the processes “WiFi Access Point Daemon” and/or “DHCP Server”, the configuration file may be corrupted. To resolve this, go to the Configuration tab on the Web Interface and press “Load Default Settings.”
D
Dorothy RodriguezSep 13, 2025
What to do if ClickShare Barco Projector Accessories Base Unit does not start up correctly?
- C
  Cindy GloverSep 13, 2025
  If the ClickShare Base Unit does not start up correctly, it could be due to a corrupted configuration file. To resolve this, browse to the Configuration tab of the Web Interface and press “Load Default Settings.”
J
jfrazierSep 15, 2025
How to fix Barco CSE-200 web interface is not accessible?
- T
  trevinorobertSep 15, 2025
  If the web interface is not accessible, it may be a browser issue. Try using another browser (version) and check the browser settings. It could also be a connection problem. There are three methods to access the web interface; refer to the corresponding chapter of the documentation. Check the proxy settings.
J
Jeffery RichardsSep 17, 2025
What causes no LAN connection with the Barco CSE-200 Base Unit?
- H
  Heidi MccannSep 17, 2025
  If there is no LAN connection with the Base Unit, it could be due to a wrong IP address, meaning the IP address is not within your LAN range. Another possible cause is that DHCP is not enabled.

Barco CSE-200 Specifications

General

HDMI Input	1
HDMI Output	1
Category	Projector Accessories
Ethernet	Yes
Wireless	IEEE 802.11 a/b/g/n
Compatibility	Windows, macOS, Android, iOS
Connectors	HDMI, Ethernet
USB	2 x USB (rear)