53R5905752 /16 DP2K C
4.6 Resetting the lamp parameters
CAUTION: The “LAMP INFO” parameters MUST be updated after each installation of a xenon lamp
inside the Lamp House. Neglecting this update will result in poor performance and short life time of
the xenon lamp.
How to reset the lamp parameters?
1. Start up the projector but do not ignite the lamp.
2. Go via the Communicator touch panel to the menu “Installation” > “Lamp” > “Lamp information”.
3. While the Lamp information window is displayed, tap on Reset (1).
A reset message is displayed (2).
4. Tap on Select (3) to display a list of possible article numbers (4). Select a article number (5) and tap OK
(6).
The software will validate the selected article number (7).
5. Fill out the serial number of the lamp (8).
6. Click Reset (9).
Image 4–26 Reset lamp info
CAUTION: For more information about using the Communicator Touch Panel consult the user's
guide of the Communicator Touch Panel.
Lamp & Lamp House
To Next Page
Loading...
Need help?
General
