EasyManua.ls Logo

Barco DP4K-P - Lamp & Lamp House

Barco DP4K-P
125 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. Lamp & Lamp House
4. LAMP & LAMP HOUSE
WARNING: DO NOT PER MIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
XENON LAM P HA NDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HANDLE THE XEN ON LAMP.
CAUTION: Xenon comp act arc lamps are highly p ressurized. When ignited, the normal operating temperature
of the bulb increases the pressure to a level at which the bulb m a y explode if not handled in strict accordan ce
to the manufacturer’s instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. W hen ever the lamp house, containing a xenon lamp , has to be dism antled or when ever
the protective container or cloth has to be removed from the xenon lamp , authorized protective clothing MU ST
be worn!
WARNING: Always wear face protection (full face shield w ith n eck p rotector) w hen handling xenon lamps.
WARNING: Alw ays wear protective clothing (welder ’s jacket) w hen handling x enon lamps.
WARNING: Alwa ys wear clean leather gloves w ith w rist p rotectors when handling xeno n lamps.
Overview
Introduction
Supported xenon lamps for the S/M Lamp House
Removal of the L amp Hou se
Removal of the xenon lamp from m anual S/M L amp House
Installation of the xenon lamp in manu al S /M Lamp House
Installation of the Lamp House
Resetting the lamp parameters
Realignment of the lamp in its reector (manual Lamp H ou
se)
4.1 Introduction
Lamp a nd Lamp House
The DP xK-19B/23B/P projector is delivered with a manual or m otorized S/M L am p House without lamp. The xeno n bulb lamp is
delivered separately and has to be installed on site by a qualied service t echnician.
The xenon bulb lamp is packed in a protective container or wrapped in a protective cloth. Never remove this protective container or
protective cloth without w e aring adequate protective clothing (face shield, clean cotton gloves, welder’s jacket).
Image 4-1
Left: Xenon lamp in protective container. Right: Xenon lamp wrapped in protective cloth.
R5905067 DPXK-19B/23B/P 17/09/2012 27

Table of Contents

Related product manuals